1. ​Measure your fabric to fit your cork board, leaving 3 inches extra on each side. Grab your scissors and cut the fabric.


​    2.Fold the fabric around the cork board. Lay the cork board down on a flat surface like a table, or the ground. Take the ribbon and begin measuring the ribbon to create a lattice effect and cut leaving an inch on each side so it will wrap around the cork

​board. TIP- using straight pins to pin the ribbon in place helped  for adding the buttons to the board.



​   








3. OPTIONAL STEP- for extra stability grab your needle and ​thread and begin sewing on the buttons on where the lattice cross.  This will help the ribbon ​stay in place better.










​   

4. Next, heat up your glue gun. Lay the fabric out on a flat surface, and place the board in the center. Make a small diagonal cut on each corner. Begin pulling the fabric tight on one side and begin gluing on​ the fabric to the back. Make sure you pull the ribbon tight and tuck​ it under the fabric.


5. Continue on the other 3 sides. When gluing the corner, simply cut the ​access fabric off and pull tightly and glue. You may need to use extra ​glue on the corners. and be sure to chop out the fabric where the hangers are.


















​   6. Hang up and Enjoy!!!!!!

What you Need:

​Lets get Started:

     Looking to spruce up your makeup room, bathroom, or even your office? Here is a fun way to spruce up your décor with your own memo board holder. It can also be used for other things like hair bows, jewelry, to do list, sunglasses, the mail and anything else you can think of.​​



DIY Hair Bow or a Memo Holder

Makeup

By

​Krista

  • 1 Cork board
  • 1/2 to a yard of fabric depending on size
  • 2 rolls of ribbon that match
  • ​Glue Gun and Glue sticks
  • ​Scissors
  • ​Straight pins (optional)
  • Buttons to match (optional)
  • ​Needle and Thread if using buttons